Herbivores, for example, Tangs, need seaweed as part of their nutritional requirement for a long and healthy life. Seaweeds also provide an adequate and balanced diet for most omnivorous and carnivorous fish.

To feed fish with pressed seaweed more efficiently, we need to both enable it to be bitten/pecked into convenient pieces, and to avoid it being pulled out as too large pieces and prevent it spreading over the tank (which is unavoidable when fixing seaweed with more traditional tools).

Our nori feeder was created by aquarists very well acquainted with feeding specifics of various types of fish, so they designed it for themselves and other hobbyists. Its ingenious construction is a result of thorough design work accompanied by extensive testing in tanks with various sorts of aquatic life.

​

Features:

​

• optimal grid size allows for efficient access for fish of various sizes and shapes;

​

• the device is well-suited for extended/prolonged fish feeding, including larger species : at maximum, it can hold an A4-size (multi-folded) nori sheet;

​

• specially designed pins pierce seaweed and securely fix the sheet all over the feeder’s surface, not only on its edges, which helps to prevent stronger fish from pulling out excessively large pieces of seaweed, The pins also allow to feed fish with small pieces of nori or slices of fish or shrimp;

​

• rounded outer edges and rims ensure very high safety and good care for even the most active or delicate fish;

​

• the feeder is easily cleaned, assembled and disassembled;

​

• it is 3D-printed from marine aquarium-safe plastic;

​

• suitable for all flat pressed seaweeds: nori, wakame etc.

​​

Simply open the feeder and place a sheet of nori or other seaweed into it (large sheets may need to be cut or folded). Snap shut the feeder and mount it onto the tank wall/glass. Please note, as a rule, fish do not take long to figure-out the new device, and quickly they start to appreciate it.

​

Size: 130х60х8 mm. (dimensions, including fastening ~160х60х8 mm.)